Yaskawa-485909模块备件

Yaskawa-485909
设置传输模式。
在“T模式”中，模块之间的接口规范通信被执行。
通常，设置为“T模式”。
只有当主站是安川MNET的定序器并且在“Y模式”下执行通信时，才能使用“Y模式”。（根据安川规范进行通信。）
有关“Y模式”的详细信息，请参阅主站的使用手册
定序器。
SW7：设置传输波特率。
可在19.2 kbps和38.4 kbps之间选择。
SW8：设置从属地址。
外部用户将JANCD-MIF05板视为从站之一
主站定序器。因此，使用SW8设置从机地址。
SW8的设定范围为“1”至“7”。
SW9：重置JANCD-MIF05板
Yaskawa-485909

Yaskawa-485909
Sets a transmission mode. In “T-mode”, a communication of interface specifications between modules is performed. Normally, set to “T-mode”. ”Y-mode” can be used only when the master station is a sequencer for YASKAWA MNET and a communication is performed in the “Y-mode”. (A communication is performed according to the YASKAWA specifications.) For the details of “Y-mode”, refer to an instruction manual of the master station sequencer. SW7: Sets a transmission baud rate. Can be selected between 19.2 kbps and 38.4 kbps. SW8: Sets a slave address. The JANCD-MIF05 board is regarded as one of the slave stations by an external sequencer, the master station. Accordingly, set a slave address by useing the SW8. The setting range of SW8 is “1” to “7”. SW9: Resets the JANCD-MIF05 board